Yamaha RS90PB Owner's Manual page 22

Control functions
If the engine oil is changed before the oil
change tripmeter appears in the display (i.e.,
before the periodic oil change interval has
been reached), the tripmeter must be reset af-
ter the oil change for the next periodic oil
change to be indicated at the correct time.
In that case, reset the oil change tripmeter as
follows.
To reset the oil change tripmeter (when the
engine oil was changed before the oil change
tripmeter appeared)
1. Push the "SELECT" button until "ODO" is
displayed, and then push the "RESET"
button for at least 1 second. The distance
traveled since the last oil change and
"OIL" will flash alternately in the odometer
display.
2. Push the "RESET" button for approxi-
mately 3 seconds. "00000" and "OIL" will
flash alternately in the odometer display 3
times, and then the display will return to
the previous display mode.
Clock
F
E
1. Clock
To set the clock
1. Turn the key to the on position.
2. Push the "SELECT" button and "RESET"
button simultaneously until the hour digits
start flashing.
16
1
3. Push the "RESET" button to change the
hour setting, and then push the "SE-
LECT" button. The minute digits will start
flashing.
4. Push the "RESET" button to change the
minute setting, and then push the "SE-
LECT" button. The clock starts when the
"SELECT" button is released.
TIP
The clock must be set again when the battery
is disconnected.
Display brightness control
This function allows you to adjust the bright-
ness of the meter unit display to suit the out-
door lighting conditions.
1. Display brightness level
To adjust the display brightness
1. Turn the key to the off position.
2. Push and hold down the "SELECT" but-
ton.
3. Turn the key to the on position, and then,
after 5 seconds, release the "SELECT"
button.
4. Push the "RESET" button to select the
desired display brightness level, and then
push the "SELECT" button. The display
returns to the previous display mode.
RST90
The multi-function meter unit is equipped with
the following:
1