Table of Contents
Advertisement
3.
Remove the screws, and then remove
the cable guide.
1
1. Screw
2. Cable guide
4.
Loosen the quick fastener screws.
1. Quick fastener screw
2. Top cover
5.
Lift up the rear of the top cover, discon-
nect the main switch coupler, and then
remove the cover.
2
1. Top cover
2. Main switch coupler
Periodic maintenance and adjustment
2
To install the top cover
1.
Connect the main switch coupler.
2.
Place the top cover in the original posi-
tion, making sure to fit the projections on
the cover into the slots in the headlight
unit.
1. Top cover
3.
Tighten the quick fastener screws.
4.
Pass the brake hose, throttle cable, park-
ing brake cable and wire harness through
the cable guide, place the cable guide in
the original position, and then install the
screws.
1
1. Cable guide
5.
Connect the auxiliary DC jack coupler.
6.
Install the left side cover and the shroud.
ECS00372
NOTICE
Make sure that all cables, hoses and
G
leads are routed properly before install-
ing the shroud and covers.
1
1
65
Advertisement
Table of Contents
