Table of Contents
Advertisement
Periodic maintenance and adjustment
When installing the shroud and covers,
G
be sure to tighten the fasteners secure-
ly.
Top cover (RST90PGT)
To remove the top cover
1.
Remove the shroud and the left side cov-
er. (See the above procedures.)
2.
Disconnect the auxiliary DC jack coupler.
1
1. Auxiliary DC jack coupler
3.
Remove the screws, and then remove
the cable guide.
1
1. Screw
2. Cable guide
4.
Pull the windshield stay rubber covers
upward.
66
1. Windshield stay rubber cover
5.
Loosen the quick fastener screws.
6.
Lift up the rear of the top cover, discon-
nect the main switch coupler, and then
remove the cover.
2
1. Top cover
2. Main switch coupler
To install the top cover
1.
Connect the main switch coupler.
2.
Place the top cover in the original posi-
tion, making sure to fit the projections on
the cover into the slots in the headlight
unit.
1
1
2
Advertisement
Table of Contents
