Control functions
TIP
Make sure that the special wrench is securely
fitted on the locknut.
1. Special wrench
Locknut tightening torque:
35 Nm (3.5 m·kgf, 25 ft·lbf)
RST90 / RST90PGT
EWS00770
WARNING
The left and right adjusting nuts must be
set to the same position. Uneven settings
can cause poor handling and loss of sta-
bility.
1.
Loosen the locknut while holding the ad-
justing nut.
44
1
2.
(b)
(a)
1. Locknut
2. Control rod adjusting nut
To increase weight transfer, turn the ad-
justing nut in direction (a), and to de-
crease weight transfer, turn it in direction
(b). WARNING! Never adjust the con-
trol rods beyond the maximum set-
ting, indicated by red paint; otherwise,
they could be damaged, which could
lead to an accident or injury.
1
2
[EWS00173]