ZyXEL Communications IES-5106M User Manual page 56

Chapter 2 Hardware Installation and Connections
Connect the Telco-50 connector end of the cable you want to use for voice service
1
to the Telco-50 connector labeled USER on the splitter chassis rear panel.
Connect the wiring on the other side of the Telco-50 cable to the upper ports of
2
the MDF using a punch-down tool.
Connect the telephone wiring from the end-user's POTS telephone equipment to
3
the lower ports of the MDF.
2.6.5.2 VoIP Installation Scenario B
In this installation scenario, you use a VoIP line card and an SEC1024 extension
card in conjunction with a DSL line card, its associated splitter card and an MDF to
provide voice service over the Internet and DSL Internet access to certain
subscribers (a DSL line card port is reserved for each user even if the user does
not subscribe to DSL). See
for more information on using the VOP1248G in conjunction with DSL line cards.
This installation scenario does not apply to G.SHDSL connections.
Figure 46 VoIP Connection Scenario B
56
Section 2.6.3 on page 48
IES-5106M / IES-5112M / IES-6000M User's Guide
and Section 2.5.3 on page 45