ZyXEL Communications IES-5106M User Manual page 54

Chapter 2 Hardware Installation and Connections
Figure 44 Installation Scenario C
Use the following procedure for this MDF installation scenario.
Connect the Telco-50 connector end of the cable you want for DSL service to the
1
Telco-50 connector labeled USER on the splitter chassis rear panel.
Connect the wiring on the other side of the Telco-50 cable to the upper ports of
2
MDF 3 using a punch-down tool.
Connect the lower ports of MDF 3 to the upper ports of MDF 2 for those users that
3
want DSL service. (Users who want telephone service only, retain the original
connection from the top port of MDF 2 to the bottom port of MDF 1.)
Connect the telephone wiring from the end-user's DSL equipment to the lower
4
ports of MDF 2.
Connect the Telco-50 connector end of the cable you want for phone service to the
5
Telco-50 connector labeled CO on the splitter chassis rear panel.
Connect the wiring on the other side of the Telco-50 cable to the lower ports of
6
MDF 4 using a punch-down tool.
54
IES-5106M / IES-5112M / IES-6000M User's Guide