Installation
MXT-1000 Installation
Any USB peripherals (mouse, keyboard, etc.) may be connected to one of the two USB ports on the rear of the
device (FIG. 9). Updates to the device's firmware are also made via the USB ports. The 5-pin Micro-USB port
is used exclusively for camera video and microphone output only.
FIG. 9
Connectors on the rear of the MXT-1000
Power via Power Over Ethernet
Power for the MXT-1000 is supplied via Power Over Ethernet (PoE), utilizing an AMX-certified, capacitive
touch-compliant PoE injector such as the PS-POE-AT High Power PoE Injector (FG423-81) or other approved
AMX PoE power source. The incoming Ethernet cable should be connected to the RJ45 port on the cable
attached to the device (FIG. 10).
RJ45 Port
FIG. 10
Back of the MXT-1000, showing RJ45 port and cable for PoE
Ethernet Cable Installation and Modification
In installations where you wish to conceal the Ethernet cable, a hole at least 1.00" (2.54 cm) in diameter is
required in the surface to allow passage of the female RJ45 connector (FIG. 11). If using a smaller hole is
unavoidable, you will need to disconnect the Ethernet cable (ECA5968-05) from the device.
The minimum diameter hole through which the Ethernet cable may pass is 0.50"
(1.27 cm).
MXD/T-1000 10.1" Modero® X Series Touch Panels
Entry for RJ45/
USB Ports
PoE Cable
Micro-USB
Port
Cable length
edited for clarity
Installation
Speaker
13