Transfer The Firmware File From The Flash Drive To The Touch Panel - AMX MXT-1000 Operation/Reference Manual

Upgrading Firmware
Make sure this is the only .kit file in this directory - if not, the latest version will be
used.
4.
Eject or unmount the flash drive from the PC.

Transfer the Firmware File From the Flash Drive to the Touch Panel

1.
Connect the USB Flash Drive to one of the USB Type A ports on the panel.
The Micro USB port cannot be used for firmware upgrades.
2.
Go to the Install Firmware setup page (Configuration->Admin->Install Firmware):
a.
Press and hold the Sleep button for 3 seconds to open the Settings page.
FIG. 23 Settings page
b.
From the Settings page, select the Configuration page. This may require entering a password.
c.
From the Configuration page, select Admin.
d.
From the Admin Configuration page, select Install Firmware.
3.
In the Firmware Installation page, select New to install new firmware from external disk.
4.
The popup page displays the name of the firmware file (for example,
"SW5968_ModeroX_v2_103_52.kit").
5.
Select Yes, and follow the directions displayed on the popup.
6.
Once the panel reboots it will perform the firmware upgrade.
After the upgrade, the unit contains the newly loaded version of firmware.
26 MXD/T-1000 10.1" Modero® X Series Touch Panels