Honeywell ICON-343C User Manual page 23

Parameter Configuration of the Icon 343C / 363C Controller (continued)
Limits/options
No. Code
[default values]
34 tIN1
35 tIN2
36 tIN3
37 tIN4
00.01...23.59
38 tIN5
39 tIN6
DFSt = rEM
40 DFst
DFS t= Loc (local)
41 StUb
0...9, A,B,C,D, E,
42 CASE
F,G,H,I,L,P,T,U,Y
Resolution
- - - -
- - - -
- - - -
- - - -
- - - -
- - - -
1 min
(remote)
0...99
[0]
[0]
22
ICON 343C / 363C USER GUIDE
Description
st nd th
1 , 2 ,...,6 defrost cycle
times: in this parameter up to six defrost
cycle starting times can be set, or the
same can be disabled (option - - - - ).
A given defrost cycle not only doesn't
occur when disabled,
deactivated, should its starting time be
during another enabled
(manual defrosting), or during a time alarm
(ALti).
If the various defrost cycle start times are
not set in the increasing order of the
parameters (e.g.,
TIM2=09.27), then the execution of the
defrost cycles will not respect the order of
said parameters, but will respect the
increasing order of real time.
Every selected defrost cycle ends when
the evaporator reaches the temperature
value set in parameter 11 (dFEt), or when
the time set in parameter 10 (dFct) ends.
During the defrost cycle the display shows
the settings made in parameter 22 (dIdF).
Local or Remote Defrost Start Modes
DFSt for defrost start mode that defines
the selection between Local or Remote
defrost operation; if DFSt= rEM the
defrost is initiated only when a network
command is issued by the Supervisor (or
®
Genus Front-End system); if DFSt= Loc
the defrost is controlled by the local
timing set by the parameters
TIN1....TIN6
Stub Number
Number given to identify refrigeration
stub from 0...99 when connected to, and
®
viewed from, a Genus network
Case number
Number given to identify refrigeration
case from 0...9...A...Y when connected
to, and viewed from, Genus
EN2B-0004UK07 R0304
starting
but is also
defrost cycle
TIM1=18.30,
®
network.