Remote Control - Hunter Ceiling fan Instructions Manual

Remote Control

Battery
Door
Phillips
Head
Screw
To access the battery compartment, remove
the small Phillips head screw that secures the
battery door to the transmitter assembly. The
battery should be installed with the positive
(+) side up. Replace with a CR2032 battery
when necessary.
If you are installing multiple remote-controlled fans on
the same circuit breaker, you may need to perform a few
extra steps to prevent interference or faulty operation of
your remote controls.
Go to www.HunterFan.com/FAQs and click
"How do I properly install multiple remote-controlled fans?"
for more information.
ON
15
M3552-01 • 05/14/14 • © Hunter Fan Company
www.HunterFan.com
Fan Off
High
Note: The remote must be paired before the
fan will operate.
Within 3 minutes of restoring power to the
fan, press both the Fan Off button and the High
button for at least 4 seconds. Your fan will turn on
low to indicate successful syncing. If it does not,
turn off power to your fan, wait 1 minute then try
again. If using the transmitter with multiple fans,
repeat this process for each fan.
1.888.830.1326