Filtration Modes For Spas Without Circulation Pump Option - Jacuzzi J-270 Owner's Manual

10.6 Filtration Modes for Spas without Circulation Pump Option

If your spa is equipped with the circulation pump option, disregard this
section and refer to page 24 for filter cycle programming details.
Standard Filtration/Heating Modes (F1-F3)
(Heater automatically turns on during any heat call while in any Standard
mode).
F1 4 hours of filtration/heating per day (one 2-hour cycle
every 12 hours).
F2 6 hours of filtration/heating per day (one 2-hour cycle
every 8 hours).
F3 8 hours of filtration/heating per day (one 2-hour cycle
every 6 hours)
Economy Filtration/Heating Modes (F4-F6)
(Heater can only turn on during an active filter cycle while
in any economy mode).
F4 4 hours of filtration/heating per day (one 2-hour cycle
every 12 hours).
F5 6 hours of filtration/heating per day (one 2-hour cycle
every 8 hours).
F6 8 hours of filtration/heating per day (one 2-hour cycle
every 6 hours)
Lock Modes (L1-L2)
L1 Lock Out (disables all spa functions to permit filter
cleaning)
L2 Lock Mode (disables the jets and light buttons to pre
vent unauthorized use of spa). Filtration/heating cycle
will continue to operate as programmed in this mode.
The temperature display flashes when this function is
enabled. Example: the "F3" filtration/heating cycle was
enabled prior to choosing lock mode. The spa continues to perform
the "F3" cycle until lock mode is canceled, allowing another cycle to
be selected.
To set a time for the first filtration/heating cycle, simply turn power on to
the spa two minutes prior to the desired time. Example: If you desire
your first filtration/heating cycle to begin at 10:00 AM turn off power
to the spa and turn it back on again at 9:58 AM. Note: start time is
approximate and may vary slightly from day to day.
page 23