Keypad Messages - Gemini GEM-DXK2 Operating Manual

The keypad can display the following functional messages. Many are two-line messages; hold down G to display the sec-
ond line. (In this booklet, both are shown simultaneously for convenience). Other diagnostic messages are available for the installer
or servicer. Should any unfamiliar messages appear, call your dealer for service.
A C O N
A C O N
EXI TXX
A C O N
DIS ARM
XXX SEC
A C O N
ARMED1
A C O N
A C O N
28
K E Y P AD M E S S AG E S
RE ADY
All zones operating; system can be armed. If displayed, a number following the "READY" display
denotes the area number. A "MONITOR ON" display indicates that Chime or Watch Mode is
on. Note: If Watch Mode is programmed, "MONITOR ON" will not display for Chime Mode.
Panel reporting to central station on arming. If necessary, wait for ringback signal before exiting.
W AI T
Exit delay in progress. XX denotes exit time remaining. If displayed, BYPASSED indicates arming
with zones bypassed; INSTANT ON indicates arming with Instant protection.
Entry delay in progress. XXX shows entry time remaining.
Panel armed. If displayed, a number following the ARMED display denotes the area number.
Zone(s) not secured (doors or windows may be open). Faulted zone(s) will scroll.
FAULT