Arming Away: Setting The Alarm When Leaving - Gemini GEM-DXK2 Operating Manual

A R M I N G AW A Y : S E T T I N G T H E AL A R M W H E N L E AV I N G
A C O N
A C O N
B Y P A S S E D A C O N
A C O N
6
Arming the System
RE ADY
Note: The keypad will autoscroll messages that are longer than one line.
1
Check the keypad. The green STATUS light must be on in order to arm. If the
green light is off, "FAULT" will display in the window followed by the number of
FAULT/
each faulted zone. Note each problem zone and secure it by closing a window,
ZONE 02
door, etc. When all zones are secure, the green STATUS light will turn on and the
window will display "READY".
Bypass faulted zones. If you cannot locate or repair the problem yourself, call
RE ADY
for assistance. If you cannot get immediate help, bypass the problem zone(s)
from the system by pressing
Bypassed zones are unprotected. If armed with zones bypassed, be sure to have
the system checked as soon as possible.
EXI T/
2
Arm the system. Enter your code and press
XX SEC
go off, the red ARMED light will turn on and the window will alternately display
"EXIT" and "XX SEC" (where "XX" represents the exit time remaining, in 10-
second steps). Note: If you enter an invalid code, the keypad will display "Wrong
Code".
3
Leave the premises. Leave through the exit door before exit time expires.
Z O N E S F A U L T E D
B
0 2 B A C K D O O R
B Y PA SS ED B Y P A S S E D
B Y PA SS ED 0 2 B A C K D O O R
, then the zone number (or vice versa). Note:
. The green STATUS light will
Q