Gemini GEM-DXK2 Operating Manual page 27

Programming Example:
Program the User 3 Code to "3784":
1. Select the Program Mode as follows:
(a)
Enter your User Code, followed by
(b)
Answer NO (press
Prog Yes/No" is displayed, then press YES (
The display will briefly read:
"User01" (User 1's Code).
2.
Press
03
3.
Press to advance to the User Code screen.
R
4.
Press
3784
If any other digits are left over from a previous User-3
Code, delete each by pressing
Note: Do not attempt to program the "OPTion" or
"ACCess" screens (if they display) as they will not be
saved.
U
5.
Press to save the code.
6.
Press to exit the Program Mode.
C
Notes:
• Note: Duplicate Codes are not allowed; therefore a dupli-
P R O G R AM M I N G ( O P T I O N A L )
R
) repeatedly until "TurnOn
Q
"UPXXXX" then
for User No. 3.
to program the code.
G 0
cate Code entered in the LCD Window will erase when
pressed.
• I f the system contains more than one keypad, only the
.
keypad designated "No. 1" may be used for programming
(if in doubt which is No. 1, ask your installer).
).
P
• While in Program Mode, the ARMED and STATUS lights
remain off and burglar and fire alarm functions are
disabled.
• In selecting your codes, do not program repetitive
numbers (1111), consecutive numbers (1234), your birth
date, address, or other obvious combinations. Choose a
code of up to six digits (a minimum of four is
recommended, and required in UL installations). If the
.
keypad detects no Program Mode activity for more than 4
minutes, a tone will sound. Press
U
is
to silence.
C
27