Using The Handset - Station Control - Raymarine Ray240 User Manual

81219_4.book Page 23 Tuesday, June 27, 2006 1:07 PM

2.3 Using the handset - station control

Note: Applicable to installations with 2 handsets.
In normal operation an installation with 2 stations has a primary and a secondary
station. The primary station can access all menu functions, the secondary station
has limited functionality. Station control enables the user to designate either
station as the 'primary' station, utilizing full functionality.
When the Ray 240 is powered, no station has control. To take station control, one
of the following must be carried out:
• taking the handset from the cradle.
If the handset was out of the cradle at power-up it must be replaced in the
cradle and then removed.
• pressing a handset button - the handset can be in or out of the cradle.
• pressing the PTT switch - the handset must be out of the cradle.
If you want to change the station in control, lift the handset of the other station,
the Station Control menu is displayed.
STEP 1
Secondry menu
Station control
Intercom/Hailer/Fog
Settings
CANCEL
STEP 3
STATION CONTROL
YES
NO
CANCEL
If the Ray240 is in standby mode, the handset used to activate the radio becomes
Note:
the handset with station control.
STEP 2
STATION CONTROL
To allow this station
to take full control
of the radio press
the "MENU" button
SELECT
BACK
You now have
station control
the following
screen appears
on the other
SELECT
handset
MENU
STATION CONTROL
This station has lost
full control of the
radio to station 2
MENU
BACK
23