Tripod And Pole Mounting; Tripod Mounting; Pole Mounting - EAW JFL213 Owner's Manual

6.4

TRIPOD AND POLE MOUNTING

6.4.1 Tripod Mounting

The JFL213 may be mounted on a tripod loudspeaker stand with a 35 mm / 1.38 in diameter
pole. The tripod loudspeaker stand must be rated to support minimum 60 kg / 132 lb. The
JFL213's integral pole-mount holes allow 0° and -15° aiming by choosing the hole specified in
Figure below. A maximum of two (2) JFL213 loudspeakers may be mounted on a tripod stand.

6.4.2 Pole Mounting

Up to two (2) JFL118 subwoofers may be used
as a base for up to two (2) pole-mounted
JFL213s. In this configuration a 35 mm / 1.38 in
diameter loudspeaker pole is inserted between
the JFL118's pole cup and either of the JFL213's
integral pole mount holes. The latter holes allow
the JFL213 to be aimed at 0° or -15° as de-
scribed in Section 6.4.1 Tripod Mounting.
The pole may be a fixed length or height ad-
justable. In either case it must be rated to sup-
port minimum 60 kg / 132 lb.
EAW's model SPM100 height-adjustable pole is
an ideal companion – see right hand Figure. A primary Quick Release Pin and secondary
clamp mechanism is used to set JFL213 height. To use:
a. Stack up to two (2) JFL118 loudspeakers on a level, stable surface.
b. Insert the SPM100 pole in the uppermost JFL118's pole mount cup.
c. Remove the pole's Quick Release Pin from its stored position and loosen the clamp handle.
d. Raise the inner pole to the desired height and insert the Quick Release pin in the nearest
through-hole.
e. Lower the inner pole so that the pin is resting atop the clamp mechanism.
f. Tighten the clamp handle so that the inner pole cannot easily rotate. Do not over-tighten;
the Quick Release Pin should bear the weight of the JFL213(s).
g. Stack up to two (2) JFL213 loudspeakers on the SPM100 pole.
CAUTION: All enclosures must be securely pinned together. To do so follow the procedures
described in the accompanying FB221 Rigging & Ground Stack Instructions.
14 JFL213 and JFL118 Loudspeakers
CAUTION: All enclosures must be securely pinned together.
To do so follow the procedures described in the accompa-
nying FB221 Rigging & Ground Stack Instructions.