Mounting Instructions - EAW VR61 Instruction Manual

Mounting Instructions

1. Remove the screw from each end of the enclosure as shown below.
2. Align the bracket slots with the mounting holes on each end of the enclosure. Make
sure the four openings in the bracket arms face upward.
3. Onto each of the two supplied hex-head screws, place a lock washer, and a flat
washer. Thread them at least three complete turns into both of the enclosure's side
mounting holes, and tighten them securely.
4. The bracket /enclosure assembly may be mounted vertically or horizontally.
5. The enclosure may be adjusted to any angle by loosening the 2 hex-head screws,
turning the enclosure to the desired angle, and then re-tightening the screws.
1/4 INCH FLAT WASHER
2 PLACES
1/4 INCH LOCK
WASHER
2 PLACES
VR62
6
– VR61 and VR62
BRACKET/WALLMOUNT
REMOVE SCREWS
FROM BOTH SIDES
MOUNTING POINT
1/4-20 THREADED HOLE
VR61
SCREW 1/4 INCH-20
X 1.25 INCH LONG
HEX HEAD
2 PLACES