Table of Contents
Advertisement
Hardware Installation
Note on Over-clocking Capability
The SY-7ISA provides over-clocking capability. Due to the over-
clocking setting your system may fail to boot up or hang during run time.
Please perform the following steps to recover your system from the
abnormal situation :
1.
Turn off system power (If you use an ATX power supply, and
depending on your system, you may have to press the power button
for more than 4 seconds to shut down the system.)
2.
Press and hold down the <Insert> key while turning on the system
power. Keep holding down the <Insert> key until you see the
message of the CPU type and frequency shown on the screen.
3.
Press the <Del> key during the system diagnostic checks to enter the
Award BIOS Setup program.
4.
Select [Save & Exit SETUP] and press <Enter> to save the new
configuration to the CMOS memory, and continue the boot
sequence.
Note: SOYO does not guarantee system stability if the user over
clocks the system. Any malfunctions due to over-clocking are not
covered by the warranty.
2-3.10 Power Off
There are two possible ways to turn off the system:
1.
Use the Shutdown command in the Start Menu of Windows 95/98
to turn off your computer.
2.
Press the mechanical power-button and hold down for over 4
seconds, to shutdown the computer. If you press the power-button for
less than 4 seconds, then your system will enter into Suspend Mode.
You are now ready to configure your system with the BIOS setup program.
Go to Chapter 3: BIOS SETUP
53
SY-7ISA
Advertisement
Table of Contents
