2-3.5 Cmos Clear (Jp5); 2-3.6 Power On - SOYO SY-7ISA User Manual

Hardware Installation

2-3.5 CMOS Clear (JP5)

In some cases the CMOS memory may contain wrong data, follow the
steps below to clear CMOS memory.
1. Clear the CMOS memory by momentarily shorting pin 2-3 on jumper
JP5. This jumper can be easily identified by its white colored cap.
2. Then put the jumper back to 1-2 to allow writing new of data into the
CMOS memory.
CMOS
Clearing
JP5 Setting
Note: You must unplug the ATX power cable from the ATX power
connector when performing the CMOS Clear operation.

2-3.6 Power On

You have now completed the hardware installation of your Motherboard
successfully.
1. Turn the power on
2. To enter the BIOS Setup Utility, press the <DEL> key while the system
is performing the diagnostic checks,
Note: If you have failed to enter the BIOS, wait until the boot up
sequence is completed. Then push the RESET button and press
<DEL> key again at the beginning of boot-up, during diagnostic
checks.
Clear CMOS Data
Short pin 2-3 for
at least 5
seconds to clear
the CMOS
Retain CMOS Data
Short pin 1-2
to retain new
settings
1 2 3
44
SY-7ISA
1 2 3