HP Vectra VE 5/series 2 User Manual page 86
Hewlett-packard personal computer user's guide
Hide thumbs
Also See for Vectra VE 5/series 2:
- User manual (102 pages) ,
- Technical reference manual (42 pages) ,
- Supplementary manual (29 pages)
Table of Contents
Advertisement
If no devices are installed on the second IDE channel, you should highlight Secondary
Integrated Channel and select Disabled. This will make more system resources available for
other system components.
IDE Primary Channel
Device 1 . . . . . . . . . . . . 840 MB
Device 2 . . . . . . . . . . . . None or SCSI
Data Transfer Speed
Translation Method . . . . . . . Standard CHS/Ext. CHS/Auto
Primary Integrated Channel . . . Enabled/Disabled
IDE Secondary Channel
Device 1 . . . . . . . . . . . . CD-ROM
Device 2 . . . . . . . . . . . . None or SCSI
Data Transfer Speed
Translation Method . . . . . . . Standard CHS/Ext. CHS/Auto
Secondary Integrated Channel . . Enabled/Disabled
Configuring the SCSI Interface
If you install a SCSI host adapter board, highlight the Integrated Interface option and select
Disabled.
Integrated SCSI Interface
Integrated Interface
SCSI BIOS . . . . . . . . . . . . Not Available/Enabled
Ultra SCSI
Do not change the Ultra SCSI option from Automatic unless you are familiar with the
restrictions of Ultra SCSI. To access advanced SCSI device configuration options, restart the
computer and press [F7] when <SCSI Setup=F7> is displayed.
Flexible Disk Drives
If you install a flexible disk drive that uses the integrated disk interface, the Setup program
should detect and configure the drive automatically.
If you have two flexible disk drives, highlight Bootable Drive and select Drive 1 or Drive 2. This
is the drive your computer will use to start (boot) from a system diskette.
Flexible Disk Drives
Drive 1 . . . . . . . . . . . . . 3.5-inch, 1.44 MB
Drive 2 . . . . . . . . . . . . . None
Bootable Drive
Interface . . . . . . . . . . . . Integrated/Controller Board
If you install a flexible disk drive that has its own controller board, highlight the Interface option
and select Controller Board. Configure the controller as described in its manual.
. . . . . . Optimized
. . . . . . Optimized
. . . . . . Enabled/Disabled
. . . . . . . . . . . Automatic/Enabled/Disabled
. . . . . . . . . Drive 1
Advertisement
Table of Contents
