HP Vectra VE 5/series 2 User Manual page 23

6 Click on the Other Adapter button, when the Select Network Adapter dialog box
appears.
7 Enter D:\LAN\IBM\OS2, when asked for the file location, and click OK.
8 The HP PCI Integrated 10/100VG Interface will be displayed in the Drivers Found dialog
box. Select Ethernet as the Type of LAN.
9 When the Select Network Adapter dialog box appears, the HP PCI Integrated 10/100VG
Interface is highlighted in the adapter list.
10 Remove the "XU/VT Drivers and Documentation" CD-ROM from the CD-ROM drive, insert
the OS/2 Warp Connect CD-ROM and then click OK.
11 Click OK in the Select Network Adapter dialog box, to accept the selection of the
adapter.
12 Click OK, then click OK again in the configuration dialog box.
13 Click the Install button in the Ready to Install window.
14 Select OK to confirm the shutdown of the operating system. Leave the OS/2 Warp
Connect CD-ROM in the drive (some files will be copied from the CD-ROM when the
operating system restarts).
Installing the HP Video Driver
After successful installation of OS/2, you should install the HP video driver from the "XU/VT
Drivers and Documentation" CD-ROM.
1 Insert the "XU/VT Drivers and Documentation" CD-ROM in the CD-ROM drive.
2 In the OS/2 System folder, open the Command Prompts folder and click on the OS/2
Full Screen icon.
3 At the command prompt, type the following:
D: [ENTER]
CD VIDEO\DISK5 [ENTER]
INSTALL /U [ENTER]
This will start an 'unattended' installation of the video drivers.
4 When the installation of the drivers has completed, exit from the command prompt,
shutdown the operating system, then restart the system.
Selecting a Display
1 In the OS/2 System folder, open the Command Prompts folder and click on the OS/2 Full
Screen icon.
2 At the command prompt, type the following:
CD \MGA\OS2 [ENTER]
MGAMON [ENTER]