HP Vectra VE 5/series 2 User Manual page 22

2 Highlight Operating System and select IBM OS/2. Press the [F3] key to save the setting
and exit the Setup program.
Installation Procedure
Consult the manual that came with your OS/2 Warp installation disks for a detailed explanation
of the installation procedure.
When the installation program prompts you to install networking support, select No. Networking
support should be installed after completing the installation of OS/2 Warp.
When the installation of OS/2 Warp has completed, two error messages will appear when your
computer is restarted:
SYS1201: The device driver C:\MMOS2\SB16D2.SYS... was not
installed
SYS1201: The device driver C:\MMOS2\AUDIOVDD.SYS... was not
installed
Press [ENTER] to continue when each error message appears. (These messages will appear
because the HP SCSI drivers have not yet been installed. You must install the HP SCSI
drivers, as described below, to prevent this error message appearing again.)
Installing the HP SCSI Drivers
To install the latest HP qualified SCSI driver for OS/2:
1 Insert the "XU/VT Drivers and Documentation" CD-ROM into the CD-ROM drive.
2 Open the OS/2 System folder, then the System Setup folder.
3 Click on the Device Driver Install icon.
4 Change the source directory for the drivers with the Change button to D:\SCSI\OS2.
5 Click the Install button. The drivers will be copied from the CD-ROM.
6 Exit from the OS/2 Device Driver installation.
7 Shutdown OS/2, then restart your computer to use the new SCSI drivers.
Installing the HP Network Drivers
To install networking support with the latest HP qualified network drivers for OS/2:
1 Insert the "XU/VT Drivers and Documentation" CD-ROM into the CD-ROM drive.
2 Open the OS/2 System folder, then open the OS/2 Warp Connect Install/Remove folder.
3 Click on Warp Connect Selective Install for Networking.
4 Select an installation on this workstation (local install).
5 Follow the instructions displayed by the installation program.