System Board - HP COMPAQ DX2710 MT Service & Reference Manual

6.13 System Board

1. Prepare the computer for disassembly
2. Remove the access panel
(MT chassis and SFF
3. Remove the front bezel
4. Disconnect the power, and data cables from the back of all installed drives.
5. Disconnect all cables from the system board.
6. Remove the heatsink from the system board
7. Remove the 6 screws that secure the system board to the chassis.
8. Slide the system board towards the front of the chassis then, angle the back of the board up to
remove it.
✎
The system board in the computer may look slightly different from the one shown here.
To install the system board, reverse the removal procedure.
The difference of mounting PCA into chassis between MT and SFF is minor, refer to different
shape chassis.
Service Reference Guide
Removal and Replacement Procedures— Microtower (MT)/Small Form Factor (SFF) Chassis
(Section 6.2, "Remove the computer access panel and front bezel
chassis)").
(Section 6.2.2, "Front Bezel (MT
483941-001
(Section 6.1, "Preparation for
Chassis)").
(Section 6.11, "Heatsink - MT
Disassembly").
chassis").
6–33