Service Considerations; Tools And Software Requirements; Screws - HP COMPAQ DX2710 MT Service & Reference Manual

5.4 Service Considerations

Listed below are some of the considerations that you should keep in mind during the disassembly
and assembly of the computer.

5.4.1 Tools and Software Requirements

To service the computer, you need the following:
■
Torx T-15 screwdriver (Compaq screwdriver with bits, PN 161946-001)
■
Torx T-15 screwdriver with small diameter shank (for certain front bezel removal)
■
Flat-bladed screwdriver (may sometimes be used in place of the Torx screwdriver)
■
Diagnostics software
■
Compaq tamper-resistant T-15 wrench (Smart Cover FailSafe Key, PN 166527-001) or
Compaq tamper-resistant bits (Smart Cover FailSafe Key, PN 166527-002)

5.4.2 Screws

The screws used in the computer are not interchangeable. They may have standard or metric
threads and may be of different lengths. If an incorrect screw is used during the reassembly
process, it can damage the unit. HP strongly recommends that all screws removed during
disassembly be kept with the part that was removed, then returned to their proper locations.
✎
Metric screws have a black finish.
U.S. (Unified Standard) screws have a silver finish and are only used on hard drives.
✎
As each subassembly is removed from the computer, it should be placed away from the work
area to prevent damage.
Service Reference Guide
Identifying the Chassis, Routine Care, and Disassembly Preparation
483941-001 5–7