To Adjust the Carrying Handle To Adjust the Carrying Handle To adjust the position, grasp the handle by the sides and pull outward. Then, rotate the handle to the desired position.
Page 26
Chapter 1 Quick Start To Rack Mount the Instrument To rack mount a single instrument, order adapter kit 5063-9240. To rack mount two instruments side-by-side, order lock-link kit 5061-9694 and flange kit 5063-9212. Be sure to use the support rails inside the rack cabinet. To install two instruments in a sliding support shelf, order support shelf 5063-9255, and slide kit 1494-0015.
Extra English manual set (local language manual files are included on the CD-ROM, Agilent part number 5964-8251) Accessories The accessories listed below may be ordered from your local Agilent Tecnologies Sales Office either with the power supply or separately. Agilent No.
The Questionable Status Register Table 4-3. Bit Definitions - Questionable Status Register The Questionable Status Event register is cleared when: The Questionable Status Enable register is cleared when:...
The Status Byte Register Table 4-5. Bit Definitions – Status Byte Summary Register...
Page 99
The Status Byte Summary register is cleared when: The Status Byte Enable register (Request Service) is cleared when: Using Service Request (SRQ) and Serial POLL...
Execution Errors Execution Errors -101 Invalid character -102 Syntax error -103 Invalid separator -104 Data type error -105 GET not allowed -108 Parameter not allowed -109 Missing parameter...
Self-Test Errors Self-Test Errors The following errors indicate failures that may occur during a self-test. Refer to the Service Information for more information.
Calibration Errors Calibration Errors Service Information...
Page 123
Calibration Errors Bad readback cal data Bad OVP cal data Cal OVP status enabled Gain out of range for Gain Error Correction Cal checksum failed, secure state Cal checksum failed, string data Cal checksum failed, store/recall data in location 1 Cal checksum failed, store/recall data in location 2 Cal checksum failed, store/recall data in location 3 Cal checksum failed, DAC cal constants...
Front Panel Voltage and Current Calibration CAL MODE hold down 2 2 2 2...
Page 185
General Calibration/Adjustment Procedure 5 Save the changes and select the middle voltage calibration point. 6 Enter the reading you obtained from the DVM by using the knob and resolution selection keys. 7 Save the changes and select the high voltage calibration point. 8 Enter the reading you obtained from the DVM by using the knob and resolution selection keys.
Page 186
General Calibration/Adjustment Procedure 2 2 2 2 Notice...
Page 187
General Calibration/Adjustment Procedure ¸ ¸...
Page 188
Calibration Record for Your Power Supply Calibration Record for Your Power Supply VOLTAGE CAL...
January 1, 2004 Date Bill Darcy/ Regulations Manager For further information, please contact your local Agilent Technologies sales office, agent or distributor, or Agilent Technologies Deutschland GmbH, Herrenberger Straβe 130, D71034 Böblingen, Germany Revision: B.00.00 Issue Date: Created on 11/24/2003 3:07...