Graco OR PRO TI1681A Instructions-Parts List Manual page 13

a. Graco WB100 Enclosure: Slide hose through
the strain relief fitting (W). Ensure conductive
layer (C) has passed through fitting. Tighten to
55 in-lb (6.2 N•m). Pull back on hose to check it
is secure. Comply with the requirements in
Warning at right. See F
C
Shielded
Hose 245252
T
A
Fig. 6. Waterborne Hose Dimensions (At Graco
WB100 Enclosure)
See Warning at right.
T
Fig. 7. Shielded Fluid Hose Connection at Graco
WB100
Unshielded
C
Hose 246431
T
A
Fig. 8.
309293J
. 6. and F . 7..
IG IG
J
B
A 14.5 in. (368 mm)
B 0.75 in. (19 mm)
TI2166A
C
W
J
Z
L
TI1897A
J
A 12.0 in (305 mm)
TI2743A
See Warning below.
T
Fig. 9. Unshielded fluid connection
WARNING
Electric Shock Hazard
For Shielded hose systems:
Conductive hose layer (C) must be
grounded through its connection to the iso-
lation system's grounded enclosure (L) or
grounded safety fence. To maintain grounding conti-
nuity, the conductive hose layer (C) must be engaged
in the ferrule when the strain relief nut is tightened.
Failure to properly install the hose in the strain relief
could result in an electric shock.
b. Non-Graco Isolated Enclosure: Connect hose
as instructed in the isolation system manual,
and comply with the requirements in the Warn-
ing at right. Refer to F
NOTE: Ground layer (C) of hose must
be grounded at isolation system.
T
C
(see note above)
Fig. 10. Shielded Fluid Hose Connection at Non-Gra-
co Isolated Enclosure
Installation
C
W
J
Z
L
TI2744A
. 10..
IG
J
L
TI1966A
13