Viewing Ties (And Muting Outputs) - Extron electronics DXP DVI Pro Setup Manual

Toggle the lock on and off by pressing and holding the Video and
Audio buttons until the following buttons blink twice (approximately
2 seconds).
The Esc, Video, and Audio buttons blink if the DXP is now in lock
•
mode 2.
The Video and Audio buttons blink if the DXP is now in lock
•
mode 1.
Press and hold
simultaneously.
VIDEO
2 seconds
VIDEO
Figure 17.
NOTE:

Viewing Ties (and Muting Outputs)

1.
Press the View button. Output buttons light for outputs that have
no ties established.
NOTES:
2. Press an input button. The buttons for all tied outputs light
(amber for video and audio, green for video only, and red for
audio only).
3. Press an output button. The buttons for the tied input and all tied
outputs light.
4. Press the View button. All input and output buttons become unlit.
18 DXP DVI Pro and DXP HDMI Series • Operation
I / O
AUDIO
I / O
The buttons blink twice.
Release the buttons.
AUDIO
Press and Hold the Two I/O Buttons Simultaneously
To switch from lock mode 1 (front panel is completely
locked) to lock mode 0 (front panel is unlocked), you must
first switch to mode 2, then from mode 2 to mode 0.
• If an output button blinks, that output is muted.
To toggle mute on and off, press and hold the
output button for 2 seconds.
•
Mutes are protected when front panel lock mode 2
is selected. You can view the status of the output
(muted or unmuted) in lock mode 2 but you cannot
change it from the front panel (see
Unlocking the Front Panel (Executive
page 16).
To enable changes to the mute settings, set the lock
mode to 0.
"Locking and
Modes)" on