Table of Contents
Advertisement
Installing and Configuring the Edge Switch 2/32
Figure 2–21: Configure Fabric Parameters dialog box
NOTE: Ordinarily, you do not need to change values in this dialog box from their defaults. The
only exception is the Preferred Domain ID. Change this value if the switch will participate in a
multiswitch fabric.
3. Use information under
parameters in this dialog box.
4. After you change settings, click the Activate button.
5. Back up the configuration data when you are finished configuring the switch.
Fabric Parameters
Configure the following parameters as required by your fabric.
BB_Credit
Configure the switch to support buffer to buffer credit (BB_Credit) from 1 through 60.
This is the value used for all ports, except those configured for extended distance
buffering (10-100 km). The default value is 16. For a description of the
buffer-to-buffer credit, refer to the industry specification, Fibre Channel Physical and
Signaling Interface.
2-30
"Fabric
Parameters" to change settings as required for
edge switch 2/32 installation guide
Advertisement
Table of Contents
