Table of Contents
Advertisement
Task 6: Configure the Switch to the HAFM Application
To manage a new switch, it must be identified to the HAFM application. To identify
the new switch:
1. Right-click in a blank area of the Product View page and select New or click
Product on the menu bar and choose New. The New Product dialog box displays,
as shown in
Figure 2–7: New Product dialog box
2. Type the IP address or DNS host name of the switch (determined by the
customer's network administrator).
3. Select edge-32 from the Product Type field and click OK. A new switch icon
displays at the Product View page.
4. Repeat
step 1
Task 7: Record or Verify HAFM Server Restore Information
Configuration information must be recorded to restore the HAFM server in case of
hard drive failure. The Windows 2000 operating system and the HAFM and Edge
Switch 2/32 Product Manager application must also be restored. Refer to the hp
StorageWorks edge switch 2/32 service manual for instructions.
To record or verify HAFM server configuration information refer to the hp
StorageWorks HAFM server installation guide for instructions.
edge switch 2/32 installation guide
Figure
2–7.
through
step 3
for each new switch.
Installing and Configuring the Edge Switch 2/32
2-13
Advertisement
Table of Contents
