Installing and Configuring the Edge Switch 2/32
2. To enable transmission of trap messages to configured SNMP management
workstations, click Enable Authorization Traps. A check mark displays in the
box when transmission is enabled, as shown in
Figure 2–27: Configure SNMP dialog box—Enable Authorization Traps
3. Click Activate to save the information and close the dialog box.
Configure and Enable E-mail Notification
Perform this procedure to configure and enable e-mail addresses and simple mail
transfer protocol (SMTP) server addresses to receive e-mail notification of switch (and
other managed product) events. The addresses must be configured at the HAFM
application, then enabled. See
page 2–50 for instructions on testing this notification feature.
To configure and enable e-mail and SMTP server addresses:
1. At the Product View page, choose Maintenance > Configure E-Mail. The
Configure E-Mail dialog box displays, as shown in
2-40
"Task 13: Test Remote Notification
Figure
2–27.
(Optional)" on
Figure
2–28.
edge switch 2/32 installation guide