Table of Contents
Advertisement
Installing and Configuring the Edge Switch 2/32
Figure 2–20: Configure Switch Parameters dialog box
Ordinarily, you do not need to change values in this dialog box from their defaults.
The only exception is the Preferred Domain ID. Change this value if the switch will
participate in a multiswitch fabric.
1. Use information under
parameters in this dialog box.
2. After you change settings, click the Activate button.
Switch Parameters
Configure the following parameters as required by your fabric.
Domain ID
The domain identification is a value between 1 and 31 that provides a unique
identification for the switch in a fabric. An Edge Switch cannot contain the same
domain ID as another switch or their E_Ports will segment when they try to join.
In the Configure Switch Parameters dialog box, a field is provided to enter a
preferred domain ID and a check box is provided to enable this ID as an insistent
domain ID.
2-26
"Switch
Parameters" to change settings as required for
edge switch 2/32 installation guide
Advertisement
Table of Contents
