Planet WRT-625G User Manual page 65

Parameters
Enable MAC Filtering
Add PC
Remove PC
Enable IP Filtering Table
Add PC
Remove PC
Delete All
After configuration complete, please click "Apply" button to save the configuration. Then you will see a
screen to prompt you the settings are saving successfully. You may press "Continue" for configure other
settings or "Apply" to restart WNRT-625G with new configuration. Please refer to section 4.2.7 for more
information about this screen.
Description
Check "Enable MAC Filtering" to enable MAC Filtering.
If select "Deny", all PCs will be allowed to access Internet accept for the PCs
in the list below.
If select "Allow", all PCs will be denied to access Internet accept for the PCs
in the list below.
Fill in "Client PC MAC Address" and "Comment" of the PC that is allowed to
access the Internet, and then click "Add". If you find any typo before adding it
and want to retype again, just click "Reset" and the fields will be cleared.
If you want to remove some PC from the "MAC Filtering Table", select the
PC you want to remove in the table and then click "Delete Selected". If you
want remove all PCs from the table, just click "Delete All" button. If you want
to clear the selection and re-select again, just click "Reset".
Check "Enable IP Filtering Table" to enable IP filter.
If select "Deny", all PCs will be allowed to access Internet accept for the PCs
in the list below.
If select "Allow", all PCs will be denied to access Internet accept for the PCs
in the list below.
You can click "Add PC" to add an access control rule for users by IP
addresses.
If you want to remove some PCs from the "IP Filtering Table", select the PC
you want to remove in the table and then click "Delete Selected".
If you want to delete all PCs. Please click this button.
65