Planet WRT-625G User Manual page 10

5. Plug in power adapter and connect to power source. After power on, WNRT-625G will start to
operate.
6. Please check all LEDs on the front panel. 'PWR' LED should be steadily on. WAN and LAN LEDs
should be on if the computer / network device connected to the respective port of the router is powered
on and correctly connected. If PWD LED is not on, or any LED you expected is not on, please recheck
the cabling, or jump to 'Troubleshooting' for possible reasons and solution.
Note:
1. ONLY use the power adapter supplied with the WNRT-625G. Otherwise, the product may be
damaged.
2. If you want to reset WNRT-625G to default settings, press and hold the RST(reset) button over
30 seconds and release. And then wait for WNRT-625G restart.
10