CDD-880 Multi Receiver Router
Ethernet Management
5.4.4.4
Configuration Pages
The 'Configuration' pages are used to configure all router parameters. Click the Interface,
Demod, ARP, or Routing tab to continue (the 'Configuration | LNB' page is inoperable at this
time).
5.4.4.4.1
Configuration | Interface
Click the FE Mgt or GE tab to continue.
5.4.4.4.1.1
Configuration | Interface | FE Mgt
The 'Configuration | Interface | FE Mgt' page (Figure 5-8) permits the user to configure the
10/100 BaseT Fast Ethernet (FE) Management (M&C) port.
FE – Management Interface
MAC Address – This parameter is read-only and cannot be changed.
IP Address / CIDR Mask – Enter the IP Address and CIDR (Classless Inter-Domain Routing)
Subnet Mask using this box (the Subnet Mask valid range is from 8 – 30).
Link Configuration – Use the drop-down menu to select the line speed and duplex setting for the
CDD-880's FE interface. The available options are:
• Auto
• 1000 BaseT / Full Duplex
(GigE only)
Note: If the configuration of the port is unknown, then "Auto" is the recommended configuration.
Figure 5-8. Configuration | Interface | FE Mgt page
• 100 BaseT / Full Duplex
• 100 BaseT / Half Duplex
5–12
Revision 0
MN-CDD880
• 10 BaseT / Full Duplex
• 10 BaseT / Half Duplex