Rear Panel - Cary Audio Design Cinema 11p Owner's Manual

CONTROLS AND DISPLAYS
Channel 7 Channel 8
+ - +
BALANCED INPUT RCA BALANCED INPUT
- -
+ +
Channel 1
1 4
1. LOUDSPEAKER BINDING POSTS (OUTPUTS)
Provide audio output. One pair of custom-made, high-current binding posts
labeled + (positive) and - (negative) are included.
These binging posts are designed to facilitate high pressure, high contact area
connections without the use of tools such as nut drivers. A simple finger-tightening
actually yields higher contact pressure than traditional hex binding posts. There is
no need to exert unusual effort when tightening.
CAUTION!
NEVER connect power amplifier outputs to any component other than a loudspeaker.
NEVER run a common ground between channels.
NEVER short-circuit power amplifier outputs.
NEVER connect power amplifier outputs to another power amplifier's outputs.
DO NOT OVERTIGHTEN the Cinema 11p binding posts. Tight, high-contact pressure
connections can be achieved with figer-tightening.
DO NOT FORCE the Cinema 11p binding post "wings" up and over a bent or oversized
connector. Doing so may result in binding post damage. If the connector obstructs
"wing"-turning, slide it into place when the binding post opening provides a snug fit.
Then, use quarter-turns to tighten the connection as needed.
2. DC TRIGGER INPUT TERMINALS
Provide DC trigger control. One 3.5mm mini-jack is available to receive 12V DC
signals from a connected component. Toggling the connected component between
on and standby will toggle the Cinema 11p into and out of standby.
POWER INPUT ( AC IN)
3.
Connect to an AC power supply using the included power supply cord.
Channel 9
Channel 10
- + -
BALANCED
RCA BALANCED INPUT RCA
-
+ - +
Channel 2 Channel 3
6
Channel 11 Channel 12
+ - + -
INPUT RCA BALANCED
BALANCED INPUT RCA
+ - +
Channel 5
Channel 4
5
9
AC POWER
+ - [ ] 117V 50Hz/60Hz
Cary Audio Design
[ ] 220V 50Hz/60Hz
Apex, NC, USA
INPUT RCA
Trigger
Input
-
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
Channel 6
3
2