Rear Panel - Cary Audio Design CPA 2 Owner's Manual

CONTROLS AND DISPLAYS

REAR PANEL

1. BALANCED INPUTS
• Accepts right-channel and left-channel balanced signals from source equipment with
balanced outputs.
• The pin assignments of these XLR-type female input are:
Refer to the operating manuals of your balanced-output line-level sources to verify that
the pin assignments of their output connectors correspond to the CPA 2. If not, wire the
cable so that the appropriate output pin connects to the equivalent input pin.
2. SINGLE-ENDED INPUTS
• Accepts right-channel and left-channel (RCA) inputs from line-level source equipment
such as tuners, CD player or SACD player.
3. ANALOG RECORD OUTPUT JACK (RCA UNBALANCED)
• Use these jacks for connection to the right-channel and left-channel tape inputs of your
recorder.
4. SINGLE-ENDED MAIN OUTPUTS
• Use these jacks for connection to the power amplifiers.
Pin 1: Signal ground
Pin 2: Signal + (non-inverting)
Pin 3: Signal - (inverting)
Connector ground lug: chassis ground
9