Top Plate Dimensions; Hsa 400 Us/Domestic Cut-Out Template - Extron electronics HSA 400 US/Domestic User Manual

Reference Information, cont'd

Top Plate Dimensions

The preferred and recommended method for cutting the table is
to use the correct size metal routing template (figure A-3 and
chapter 2, "Installation") and a router. See the part numbers for
the templates on page A-5.
USER ACCESS
Figure A-3 — HSA metal routing template
If you choose not to use the metal routing template available
from Extron, the cut-out templates (figure A-4, figure A-5,
figure A-6, and figure A-7) on the following pages will help you
properly prepare the mounting surface. The cutout templates
are not to scale and are for reference only. The surface cut-out
area dimensions on all templates are C and D and marked in
bold type.
For full size paper templates, visit the Extron Web site
(www.extron.com) or call the Extron S
Support Hotline.
HSA 400/402 Series • Reference Information
A-6
USER ACCESS
EXTRON ELECTRONICS
3 Sales & Technical
US Model
6.425" (16.32 cm)
4.475" (11.37 cm)
SURFACE CUT-OUT
6.663"
AREA = 8.113 0.0325"
(16.92 cm)
(20.61 0.083 cm) x
5.925 0.0325"
(15.05 0.083 cm)
8.613"
(21.88 cm)
+
C = 8.113 0.0325"
+
(20.61 0.083 cm)
Cut surface material
out along this line.
TEMPLATE IS NOT FULL SIZE.
Cut-Out Template for Extron's HSA 400
Figure A-4 — HSA 400 US/domestic cut-out template
HSA 400/402 Series • Reference Information
+
+
+
+
+
+
G
H
Cut-Out Radius:
Tilting Plate Top Panel
0.25" (0.6 cm)
A-7