Display Assembly - HP ProBook 6475b Maintenance And Service Manual

Display assembly

NOTE: The display assembly is spared at the subcomponent level only. For more display assembly
spare part information, see the individual removal subsections.
Before removing the display assembly, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
a. Service cover (see
b. Hard drive (see
c. Optical drive (see
d. WLAN module (see
e. WWAN module (see
f. Fan (see
g. Keyboard (see
h. Base enclosure (see
i. Function board (see
j. System board (see
Remove the display assembly:
1. Position the computer with the front toward you.
2. Remove the four Phillips PM2.5×7.0 screws (1) that secure the display assembly to the computer.
3. Swing the display hinges (2) up and back until the top cover is free for removal.
Battery on page
Service cover on page
Hard drive on page
Hard drive on page
WLAN module on page
WWAN module on page
Fan on page 75)
Keyboard on page
Base enclosure on page
Function board on page
System board on page
55), and then remove the following components:
57)
62)
62)
70)
68)
76)
80)
93)
95)
Component replacement procedures
107