Vnr 100 Power Up Procedure; Vnr 100 Power Down Procedure; Initial Configuration Of The Vnr 100 - Extron electronics VNR 100 User Manual

VNR 100 Power Up Procedure

NOTE: Before turning on the VNR 100, ensure all necessary devices are connected
Power up the VNR 100 by pressing the Power button (
up.

VNR 100 Power Down Procedure

Power off the VNR 100 by pressing and releasing the front panel power button. The
recorder takes approximately 20 to 30 seconds to power-down.

Initial Configuration of the VNR 100

The initial configuration of the VNR 100 allows it to connect to the Enterprise Controller.
Once it is integrated into the Enterprise Controller network, the VNR 100 will be completely
controlled by the Enterprise Controller.
By default, the VNR 100 is pre-configured with the following network settings:
•
•
•
You will need to contact your network administrator to find out the IP address for the
Enterprise Controller.
To perform the initial configuration, follow these instructions:
1.
2.
correctly and powered up.
IP Address: 192.168.254.254
Subnet Mask: 255.255.225.0
Port Number: 8080
Initial configuration is through the browser of a computer connected to the
same network as the VNR 100. In the browser address bar, enter the IP
address of the recorder followed by a colon and the port number (for example:
192.168.254.254:8080).
The login page opens:
Figure 9. VNR 100 Login to Web Page
Enter the and
Username Password
NOTE: By default, the
Username
g
in figure
.
and the are both
Password
VNR 100 • Configuration and Hardware Setup
8). The VNR 100 boots
.
config
12