Panels And Cabling; Rear Panel Features - Extron electronics VNR 100 User Manual

Panels and Cabling

This section provides information on:
•
•
•

Rear Panel Features

Figure 5. VNR 100 Rear Panel
a
b
c
d
e
f
g
h
Rear Panel Features
Front Panel Cover
Front Panel Features
b d
a c d e
AC power connector — use a standard IEC power cord to connect the recorder to a
100 to 240 VAC, 50 or 60 Hz power source.
PS/2 port for mouse (optional) — connect a PS/2 mouse to this port, if required.
PS/2 port for computer keyboard (optional) — connect a PS/2 keyboard to this
port, if required.
USB ports (2) — used to connect a mouse and keyboard for the initial configuration.
There are a total of four USB inputs: two rear panel and two front panel.
RS-232 control port — use an Extron cable (not provided) to connect the VNR 100 to
a control PC.
VGA output connector — connect a local VGA monitor to this output.
Ethernet port 0 (eth0) — use an RJ-45 cable to connect this port to the primary
network (the VN-Matrix network).
Ethernet port 1 (eth1) — is not functional. Do not connect this port to a network.
f g h
VNR 100 • Panels and Cabling 8