Pride Mobility VICTORY SPORT Owner's Manual page 34

V I . C O M F O R T A D J U S T M E N T S
POSITIONING BELT (OPTIONAL)
Your scooter seat may be equipped with an auto-type positioning belt that can be adjusted for operator
comfort. See figure 20. The positioning belt is designed to help support the operator so that he or she does
not slide down or forward in the seat. The positioning belt is not designed for use as a restraining device.
To install the positioning belt (if required):
1. Remove the seat from your scooter.
WARNING! The positioning belt should be secured at all times. Never allow the
positioning belt to hang or drag on the floor as it may become entangled.
2. Place the seat upside down so that you can see the bottom of the seat base. See figure 19.
3. Use a wrench to remove the two rear bolts on the outermost part of the seat frame.
4. Insert the bolts through the appropriate ends of the positioning belt and then reinstall the bolts back
into the seat frame.
5. Tighten the bolts.
To adjust the positioning belt for operator comfort:
1. Insert the metal tab on the right side of the belt into the plastic housing on the opposite strap until you
hear a "click." See figure 20.
2. Pull the strap on the right side of the belt until it is secure, but not so tight as to cause discomfort.
To release the positioning belt:
1. Press the push button mechanism on the plastic
housing.
MANDATORY!
positioning belt is properly secured
to the scooter and is adjusted for
operator comfort before each use.
MANDATORY!
positioning
damaged parts before each use of
the scooter.
problem, contact your authorized
Pride Provider for maintenance and
repair.
34
Make sure the
Inspect the
belt for loose or
If you discover a
www.pridemobility.com
Figure 20. Positioning Belt
Victory Sport