Lenovo ThinkServer TD340 User Manual And Hardware Maintenance Manual page 53

The following illustrations show the connectors on a 3.5-inch hot-swap hard-disk-drive backplane.
Figure 22. Front view of the 3.5-inch hot-swap hard-disk-drive backplane
1
Slot 0 for a 3.5-inch SATA or SAS hot-swap hard
disk drive
2
Slot 1 for a 3.5-inch SATA or SAS hot-swap hard
disk drive
Figure 23. Rear view of the 3.5-inch hot-swap hard-disk-drive backplane
1 8-pin power connector
• For the 3.5-inch hot-swap hard-disk-drive backplane on the lower hard-disk-drive cage, connect the P5
power connector of the power supply to the 8-pin power connector on the backplane.
• For the 3.5-inch hot-swap hard-disk-drive backplane on the upper hard-disk-drive cage, connect the P4
power connector of the power supply to the 8-pin power connector on the backplane.
2
Mini-SAS signal cable connector 0
Used to connect the mini-SAS connector on one end of the mini-SAS signal cable.
3
Slot 2 for a 3.5-inch SATA or SAS hot-swap hard disk drive
4
Slot 3 for a 3.5-inch SATA or SAS hot-swap hard disk drive
.
Chapter 3 Product overview
41