Lenovo ThinkServer TD340 User Manual And Hardware Maintenance Manual page 183

3. Lay the server on its side for easier operation.
4. Remove the front system fans. See "Replacing the front system fan 1" on page 183.
5. Record the cable routing and connection. Then, disconnect the power supply assembly cables from
the system board and all drives. For server models with hot-swap hard disk drives, you also need to
disconnect the power cables from the hot-swap hard-disk-drive backplanes.
6. Release the power supply assembly cables from the cable clips and ties in the chassis.
7. Remove the four screws
then push the power supply assembly from the rear until it is released from the metal retaining tab
Then, carefully lift it out of the chassis.
Figure 111. Removing the non-hot-swap power supply assembly
8. Touch the static-protective package that contains the new power supply assembly to any unpainted
surface on the outside of the server. Then, remove the new power supply assembly from the package
and ensure that the new power supply assembly is the correct replacement. See "Features" on page 7
for information about the supported power supply assembly.
1 at the rear of the chassis that secure the power supply assembly, and
.
Chapter 6 Installing, removing, or replacing hardware
2 .
171