Table of Contents
Advertisement
DCA-220SSJ/SSJU — GENERATOR START-UP PROCEDURE (AUTO MODE)
WARNING - AUTO MODE MAINTENANCE
When running the generator in the AUTO mode, remember
the generator can start up at any time without warning.
NEVER attempt to perform any maintenance when the
generator is in the auto mode.
CAUTION - ENGINE SPEED SWITCH
The Engine Speed Switch must be set to the "High"
position when running in the Auto-Start mode. Failing to
set the switch in the proper position can result in damage
to your generator when it turns on.
NOTICE
When the MPEC control switch is placed in the AUTO
position, the engine glow plugs will be warmed and the
engine will start automatically.
DCA-220SSJ/SSJU — OPERATION AND PARTS MANUAL — REV. #0 (02/04/14) — PAGE 55
When starting generator in AUTO mode use the " Manual
Start-up" procedure except where noted (see below).
1. Perform steps 1 through 6 in the Before Starting section
as outlined in the Manual Starting Procedure .
2. Place the engine speed switch (Figure 54) in the HIGH
position
Figure 54. Engine Speed Switch (High)
3. Place the MPEC Control Switch (Figure 55) in the AUTO
position
Figure 55. MPEC Control Switch (AUTO)
4. Continue operating the generator as s outlined in the
Manual Start-up procedure (start at step 5).
1
Advertisement
Table of Contents
