Set Up And Attach A Print Queue - Axis NPS 550 User Manual

Section 6: Setup for Unix systems

Set up and attach a print queue

Up-load axinstall
50
The final step is done using the axinstall script, which is up-loaded from
the NPS 550 to your host using FTP. You don't need any technical
knowledge about your Unix system; axinstall will automatically detect
your system's characteristics, and guide you through the setup procedure.
Below is a list of Unix systems that are supported by axinstall:
* BSD (Berkley Unix)
SunOS 4 (Sun BSD, Solaris 1.x)
ULTRIX (Digital Equipment, DEC)
DEC OSF/1 (Digital Equipment, Alpha)
FreeBSD (Berkley Unix)
* SYS V R3 (Unix System V Release 3)
SCO (Santa Cruz Operation)
If your particular system isn't listed, axinstall tries to use one of the
generic Unix systems (BSD, SYS V R3 or SYS V R4). If axinstall fails to
recognize your system, complete the setup manually as described in the
Axis NPS Print Server Technical Reference.
1. Log in to the NPS 550 with the command ftp <host name>, where
host name is the name assigned in your system host table (e.g. sales-
dept). You will be prompted for user id and password. Enter root as
user id, and pass as password.
2. Up-load the script using the command get axinstall.
3. Log out using quit, bye or exit (depending on your FTP version).
IRIX (Silicon Graphica, SGI)
BOS (BULL DPX 2)
* SYS V R4 (UNIX System V Release 4)
SunOS 5 (Sun SYS V, Solaris 2.x)
HP-UX (HP 9000)
AIX (IBM RS/6000, BULL DPX 20)
Axis NPS 550 User's Manual