Wireless Statistics - TP-Link TL-WR1043ND User Manual

poor network performance since excessive packets. 2346 is the default setting and is
recommended.
 DTIM Interval - This value determines the interval of the Delivery Traffic Indication
Message (DTIM). A DTIM field is a countdown field informing clients of the next window
for listening to broadcast and multicast messages. When the router has buffered
broadcast or multicast messages for associated clients, it sends the next DTIM with a
DTIM Interval value. You can specify the value between 1-255 Beacon Intervals. The
default value is 1, which indicates the DTIM Interval is the same as Beacon Interval.
Enable WMM - WMM function can guarantee the packets with high- priority messages

being transmitted preferentially. It is strongly recommended enabled.
 Enable Short GI - This function is recommended for it will increase the data capacity by
reducing the guard interval time
Enabled AP Isolation - This function can isolate wireless stations on your network from

each other. Wireless devices will be able to communicate with the router but not with
each other. To use this function, check this box. AP Isolation is disabled by default.

Note:
If you are not familiar with the setting items in this page, it's strongly recommended to keep
the provided default values; otherwise it may result in lower wireless network performance.
4.6.5

Wireless Statistics

Choose menu "Wireless→Wireless Statistics", and then you can see the MAC Address, Current
Status, Received Packets and Sent Packets for each connected wireless station.
MAC Address - The connected wireless station's MAC address

Current Status - The connected wireless station's running status, one of

STA-ASSOC / STA-JOINED / WPA / WPA-PSK / WPA2 / WPA2-PSK / AP-UP / AP-DOWN /
Disconnected
Received Packets - Packets received by the station

TL-WR1043ND
.
Figure 4-25 The router attached wireless stations
300Mbps Wireless N Gigabit Router
-42-
STA-AUTH /