TP-Link TL-WR1043ND User Manual page 47

 Version - you can choose the version of the WPA-PSK security on the drop-down list. The
default setting is Automatic, which can select WPA-PSK (Pre-shared key of WPA) or
WPA2-PSK (Pre-shared key of WPA) automatically based on the wireless station's
capability and request.
 Encryption - When WPA-PSK or WPA is set as the Authentication Type, you can select
either Automatic, or TKIP or AES as Encryption.

Note:
If you check the
find a notice in red as shown in
 PSK Password - You can enter ASCII characters between 8 and 63 characters or 8 to 64
Hexadecimal characters. The default password is the same with the default PIN code,
which is labeled on the bottom of the router or can be found in Figure 4-2 .

Group Key Update Period - Specify the group key update interval in seconds. The value
should be 30 or above. Enter 0 to disable the update.
 WPA/WPA2- Enterprise - It's based on Radius Server.
 Version - you can choose the version of the WPA security on the drop-down list. The
default setting is Automatic, which can select WPA (Wi-Fi Protected Access) or WPA2
(WPA version 2) automatically based on the wireless station's capability and request.
 Encryption - You can select either Automatic, or TKIP or AES.

Note:
If you check the WPA/WPA2-Enterprise radio button and choose TKIP encryption, you will
find a notice in red as shown in Figure 4-20.
 Radius Server IP - Enter the IP address of the Radius server.
TL-WR1043ND
WPA/WPA2-Personal
Figure 4-19.
Figure 4-19 WPA/WPA2 – Personal
Figure 4-20 WPA/WPA2 - Enterprise
300Mbps Wireless N Gigabit Router
radio button and choose TKIP encryption, you will
-37-