Connecting Cable; Disconnecting Cable; Using The Internal Modem - Toshiba TE2000 User Manual

Connecting cable

To connect the LAN cable, follow the steps below.
Connect the AC adaptor before connecting the LAN cable. The AC
adaptor must remain connected during LAN use. If you disconnect the AC
Adaptor while the computer is accessing a LAN, the system may hang up.
1. Turn off the power to the computer and to all external devices
connected to the computer.
2. Plug one end of the cable into the LAN's jack. Press gently until you
hear the latch click into place.
3. Plug the other end of the cable into a LAN hub connector. Check with
your LAN administrator before connecting to a hub.

Disconnecting cable

To disconnect the LAN cable, follow the steps below.
1. Pinch the lever on the connector in the computer and pull out the
connector.
2. Disconnect the cable from the LAN hub in the same manner. Check
with your LAN administrator before disconnecting from the hub.

Using the internal modem

This section describes how to make settings and connect the modem.
Refer to the computer's online help files for more information. Refer also
to the online help files for your modem software.
The internal modem does not support the voice functions described in the
help files. All data and fax functions are supported.
In case of a lightning storm, unplug the modem cable from the telephone
jack.
Do not connect the modem to a digital telephone line. A digital line will
damage the modem.
TOSHIBA TE2000
Connecting the LAN cable
Operating Basics
4-14