Pointing Device; Serial Mouse - Toshiba TE2000 User Manual

Pointing device

If you are using a PS/2 or serial mouse, also refer to Chapter 8, Optional
Devices, and to your mouse documentation.
AccuPoint II
Problem
On-screen pointer
does not respond to
AccuPoint II
operation
PS/2 mouse
Problem
On-screen pointer
does not respond to
PS/2 mouse
operation

Serial mouse

Problem
On-screen pointer
does not respond to
serial mouse
operation
TOSHIBA TE2000
Procedure
If a PS/2 or serial mouse is connected, check the
HW Setup window. The Pointing Device
option should be set to Simultaneous to use
both the AccuPoint II and an external PS/2
mouse.
If problems persist, contact your dealer.
Procedure
Check that the PS/2 mouse cable's 6-pin
connector is firmly connected to the PS/2
mouse/keyboard port.
You may have connected the mouse after turning
the computer on. Turn off the computer, make
sure the mouse is firmly connected and turn the
computer back on.
Is your software configured to recognise the
mouse? Check the software documentation.
If problems persist, contact your dealer.
Procedure
Check for a firm connection between the
computer's serial port and the cable's 9-pin
connector.
Did you connect the mouse before turning on the
computer?
Is your software configured to recognise the
mouse? Check the software documentation.
If problems persist, contact your dealer.
Troubleshooting
9-15