Table of Contents
Advertisement
T
ROUBLESHOOTING
The following guide is for reference purposes only. Contact a Metrologic
representative at 1-800-ID-METRO or 1-800-436-3876 to preserve the limited
warranty terms on page 20.
S
YMPTOMS
No LEDs, beep and
there is no visible laser
No LEDs, beep and
there is no visible laser
After scanning a bar
code, the Red and
Green LEDs are on,
but no data is being
transmitted to the host.
USB Keyboard Emulation
After scanning a bar
code, the scanner
beeps, but the
characters appear
incorrectly in your
application.
The scanner powers
up, but does not scan
and/or beep.
G
UIDE
P
C
OSSIBLE
AUSE
No Power is being
supplied to the
scanner
No power is being
supplied from the
USB port.
The scanner is not
programmed properly
for communication
with the host.
The scanner is not
programmed
correctly.
The incorrect country
has been selected.
The scanner is trying
to scan a particular
bar code symbology
that is not enabled
(
)
S
Make sure the cable is
plugged into the host.
Check the host system's
power cable, the outlet and
power strip.
The IS4220 requests
100mA from the USB port.
If the USB port cannot
supply this, a notification
window will appear on the
screen.
Re-program the scanner
using the appropriate codes
for your scanner model.
Re-program the scanner
using the appropriate codes
for your scanner model.
Verify that the type of bar
code being read is
enabled.
S
OLUTION
19
Advertisement
Table of Contents
